What are the structural features of the overlapping shuttle tramcar/ How to improve the overlapping shuttle car?

1. The original two parallel driven pneumatic motors were replaced by a 20 horsepower vane type pneumatic motor and a planetary reducer, and the open drive was changed to a closed drive. In this way, not only the shortcomings of crowded transmission mechanism, difficult maintenance and serious gear wear are overcome, but also the whole shuttle car parts can be manufactured by itself except for standard parts.

2. The power device is connected to the reducer with a flange. If necessary, it can be driven by a motor at any time. It can be used for both wind and electricity.

3. In the lifting mechanism of the overlapping shuttle car, the cylinder that is easy to manufacture is used to replace the cylinder. Practice has proved that the cylinder can also work reliably.

4. The bogie device with 8 wheels is used for the shuttle car. After improvement, it can not only run on the curve with small radius of curvature, but also speed up the running speed. Besides that the accidents of falling off the road are rare, it is also very convenient to unload slag in the waste rock yard.